Overall rating | ☆☆☆☆☆ |
Overall rating |
Excellent build.
Overall rating |
Overall rating |
Well build only canvas protector is not holding very well. You need to have some additional support for it
Overall rating |
Overall rating |
Excellent stove! Exterior will discolor and slightly rust (it's not stainless steel) so keep it dry and/or coat it with oil or high-temp paint if that bothers you. The door does warp slightly, which causes the air-intake knob to stick in whatever position it is in before it heats up. The top and bottom have a reinforced baffle so they don't warp much at all. My only real complaint is that the stove jack (metal shield) that protects the tent fabric as the chimney pipe passes through the opening is only secured to the pipe by friction. Mine slid down the chimney pipe and slammed onto the top of the stove many times when the wind blew strongly; scared the hell out of me when I was sleeping. I'll probably make some kind of wing-nut/screw device to hold secure it better; or continue to use one of the drying rack/kettle holder arms to keep it from slamming down onto the stove top.
Overall rating |
Overall rating |
He does his job well in Helsport 8 - 10 tents. It is a good idea to make the first firing hot enough, as the door will twist quite strongly and completely jam the air intake and lock. After this, the door needs to be adjusted. One rib went from the barrel cover to walk when it was a little windy.
Overall rating |
Overall rating |
Dear Varuste-Team, today I happily recieved the spare Helsport Tent Oven. Thank you for your immediate and customers friendly service. Also a big thank you, that I can keep the damaged one. I will try to repair it and use the pipe as spare parts and the stove with the children’s of my adventure club, when we met again after Corona. Thx a lot and kind regards Tom
The Stove works fine but the stove attachment point is spot welded. Seen multiple times that the spots fail and the whole chimney falls in. There are two solutions: 1. get a welder to fix add spots and weld it tight. 2. add a pipe clamp on the attachment so it can not move as much nor fall in. Overall the stove is fine, stabile and has a afterburner section meaning the flame will not go straight to the tube meaning better efficiency.